Security and authentication
10.3 Management Access Control List
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
428 Configuration Manual, 10/2015, C79000-G8976-C351-05
no vap communication with ethernet (access point)
Description
With this command, you specify that the client cannot communicate via the Ethernet
interface.
Note
This command is available only in access point mode.
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Call the command without parameter assignment:
no vap communication with ethernet
The communication option is disabled.
You display the settings with the show wlan security <vapX 0/Y> command.
You enable the function with the
vap communication with ethernet command.
vap communication with ethernet (access point) (Page 427)
Management Access Control List
This section describes the commands relevant for working with the management access
control list.
To Next Page
Loading...
Need help?
General
