Network protocols
7.5 SMTP client
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
356 Configuration Manual, 10/2015, C79000-G8976-C351-05
no smtp-server
Description
With this command, you delete an SMTP server entry.
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Call up the command with the following parameters:
no smtp-server { ipv4 <ucast_addr> | fqdn-name <FQDN)>}
The parameters have the following meaning:
Keyword for an IPv4 address
IPv4 address of the SMTP server Enter a valid IPv4 unicast ad-
dress.
Keyword for a domain name
Domain name (Fully Qualified Domain
Maximum of 100 characters
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 25)".
The SMTP server entry is deleted.
You configure an SMTP server entry with the smtp-server command.
To Next Page
Loading...
Need help?
General
