Configuration
3.2 Load and Save
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
69
WLANAuthlog File with entries from the WLAN Authentication Log
(information on successful or failed authentication
X --
WLANCert
(in client mode only)
User certificate. You can specify a password for the
user certificate on the WBM page "Load&Save >
Password".
X X
WLANServerCert
Server certificate X X
WLANSigRec
(in client mode only)
The zip file contains the following:
• csv file with the measured values of the signal
recorder
• pdf file with the measured values and an addition-
al graphic representation of the measured values.
You will find information about the measured values
and their graphic representation in the section "
Signal
X --
WLANSpectru-
mAnalyzer
(Only in access
point mode)
The Zip file contains a csv file with the measured
values of the spectrum analyzer.
You will find information about the measured values
and their graphic representation in the section "Auto-
X --
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
do show cli-console-timeout
To Next Page
Loading...
Need help?
General
