Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
175
wlan channel (Access Point)
Description
With this command, you specify the channel via which the access point communicates with
the client.
Note
This command is available only in access point mode.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call up the command with the following parameters:
wlan channel { show-channels | <number(0=auto)> }
The parameters have the following meaning:
Lists the available channels.
Channel number
If you want the access point to
search for a free channel itself, use
Enter the channel number.
Default setting for both frequency
bands:
The channel is set.
You display the setting with the show wlan ap <wlan 0/X> command.
To Next Page
Loading...
Need help?
General
