Functions specific to SCALANCE
4.3 iPCF
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
101
Call up the command with the following parameters:
show wlan ipcf <wlan 0/X>
The parameter has the following meaning:
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The iPCF settings are displayed.
WLAN Interface Configuration mode
This section describes commands that you can call up in the WLAN Interface Configuration
mode. Depending on the Interface selected, various command sets are available.
In the Global Configuration mode, enter the
interface wlan 0/X command to change to this
mode.
● If you exit the WLAN Interface Configuration mode with the
exit command, you return to
the Global Configuration mode.
● If you exit the WLAN Interface Configuration mode with the
end command, you return to
the Privileged EXEC mode.
Note
The command is only available with the following device:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
With this command, you enable the iPCF mode.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
To Next Page
Loading...
Need help?
General
