Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
303
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
ip dhcp client mode {mac|client-id<client-id>|sysname}
The parameters have the following meaning:
The client registers with its MAC address
The client registers with the assigned ID -
The client registers with the assigned system
name
-
The registration mode of the DHCP client is configured.
This section describes commands relevant for configuring the DHCP server.
The connected devices are configured so that they obtain the IPv4 address from a DHCP
server.
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
do show cli-console-timeout
To Next Page
Loading...
Need help?
General
