Siemens SIMATIC NET Configuration Manual

Network protocols
7.4 SNMP
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
326 Configuration Manual, 10/2015, C79000-G8976-C351-05
7.4.1.3
show snmp engineID
Description
This command shows the SNMP identification number of the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show snmp engineID
Result
The SNMP identification number of the device is displayed.
7.4.1.4
show snmp filter
Description
This command shows the configured SNMP filters.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show snmp filter
Result
The configured SNMP filters are displayed.

Siemens SIMATIC NET Specifications

General

Category	Industrial Communication Software
Manufacturer	Siemens
Operating Systems	Windows, Linux
Protocols Supported	PROFIBUS, PROFINET, OPC UA
Compatibility	Siemens PLCs, Third-party devices with supported protocols