Siemens SIMATIC NET Configuration Manual

Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
36 Configuration Manual, 10/2015, C79000-G8976-C351-05
Result
The configuration for the timeout is displayed.
3.1.1.2
show coordinates
Description
This command shows the system coordinates.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show coordinates
Result
The system coordinates are displayed.
3.1.1.3
show device information
Description
This command shows information about the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show device information

Siemens SIMATIC NET Specifications

General

Category	Industrial Communication Software
Manufacturer	Siemens
Operating Systems	Windows, Linux
Protocols Supported	PROFIBUS, PROFINET, OPC UA
Compatibility	Siemens PLCs, Third-party devices with supported protocols