Siemens SIMATIC NET

SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
381
Security and authentication
10
This part contains the sections that describe the access rights and authentication methods.
10.1
User rights management
This section describes commands for access as administrator and the configuration of the
authentication methods.
10.1.1
change password
Description
With this command, you change the password of the logged in user.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
change password <passwd>
The parameter has the following meaning:
Parameter
Description
Range of values / note
password
Keyword for a password
-
passwd
Value for the password Enter the password.
The password must be at least 6 charac-
ters long.