Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
404 Configuration Manual, 10/2015, C79000-G8976-C351-05
The WEP or AES key is inserted in the key table.
You display the settings with the show wlan security <wlan 0/X> command.
wlan security ssid
Description
With this command, you assign the SSID of a WLAN interface a security context.
Note
iPCF or iPCF-MC mode activated
If the iPCF or iPCF
-MC mode is enabled, you can only select security context 1.
You are in the Interface configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call up the command with the following parameters:
wlan security ssid <index (1-8)> context <ID (1-8)>
The parameters have the following meaning:
Keyword for a security context
Enter a valid security context ID. Available only in client mode
The security context was assigned.
You create a security context and change to the security context configuration mode with the
command
wlan security context.
You display the setting with the
show wlan ssid-table command.
To Next Page
Loading...
Need help?
General
