Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
190 Configuration Manual, 10/2015, C79000-G8976-C351-05
no wlan dfs multi-radar-detection
Description
With this command you disable access points exchanging information about radar signals
among themselves and verifying them.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call the command without parameter assignment:
no wlan dfs multi-radar-detection
The function is disabled.
You display the setting with the show wlan advanced <wlan 0/X> command.
You enable the function with the
wlan dfs multi-radar-detection command.
wlan dtim (access point)
Description
With this command, you configure the DTIM interval. The DTIM interval (1-15) specifies the
number of beacons to be sent before the access point sends the packets
(broadcast/unicast/multicast) to the client.
If, for example, you enter "5", this would mean that the access point collects the packets and
sends them after every fifth beacon.
Note
This command is available only in access point mode.
To Next Page
Loading...
