Siemens SIMATIC NET

Network protocols
7.5 SMTP client
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
358 Configuration Manual, 10/2015, C79000-G8976-C351-05
Syntax
Call the command without parameters:
no sender mail-address
Result
The e-mail name of the sender is reset.
Further notes
You configure the e-mail name of the sender with the sender mail-address.
You display the setting with the
show events sender email command.
7.5.2.5
smtp-port
Description
With this command, you configure an SMTP port.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
smtp-port <smtp-port(1-65535)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
smtp-port
Value for the SMTP port 1 ... 65535
Default: 25
Result
An SMTP port is configured.
Further notes
You can reset the setting to the default with the no smtp-port command.
You display the setting with the
show smtp-port command.