Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
146 Configuration Manual, 10/2015, C79000-G8976-C351-05
show wlan ssid-table (client)
Description
This command shows a table with the SSIDs of the access points to which the client device
can establish a wireless link.
Note
This command is only available in the client mode.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show wlan ssid-table <wlan 0/X>
The parameter has the following meaning:
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The table with the SSIDs configured on the client and their status is displayed.
To Next Page
Loading...
Need help?
General
