Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
427
vap communication with ethernet (access point)
Description
With this command, you specify that the client can communicate via the Ethernet interface.
Note
This command is available only in access point mode.
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Call the command without parameter assignment:
vap communication with ethernet
The communication option is enabled.
You display the settings with the show wlan security <vapX 0/Y> command.
You disable the function with the
no vap communication with ethernet command.
no vap communication with ethernet (access point) (Page 428)
To Next Page
Loading...
Need help?
General
