Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
230 Configuration Manual, 10/2015, C79000-G8976-C351-05
switchport access vlan
Description
With this command, you assign an VLAN to an interface and configure the port VLAN
identifier (PVID) for it.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
switchport access vlan <vlan-id(1-4094)>
The parameter has the following meaning:
Number of the addressed VLAN
The Interface is added to the VLAN as an untagged port and the corresponding VLAN ID is
set.
You can reset the setting to the default with the no switchport access vlan command.
You display the setting and other information with the
show vlan port config command.
no switchport access vlan
Description
With this command, you reset the setting for the port VLAN identifier (PVID) for an interface
to the default value.
The default value is 1.
To Next Page
Loading...
Need help?
General
