Siemens SIMATIC NET Configuration Manual

Network protocols
7.4 SNMP
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
324 Configuration Manual, 10/2015, C79000-G8976-C351-05
Parameter
Description
Range of values / note
client-id
Keyword for a DHCP
client ID
-
string
Freely definable
DHCP client ID
Enter the required designation.
Result
The assignment is deleted.
Further notes
You configure the assignment with the static-lease command.
7.4
SNMP
This section describes commands of the Simple Network Management Protocol (SNMP).
7.4.1
The "show" commands
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
Example
do show cli-console-timeout

Siemens SIMATIC NET Specifications

General

Category	Industrial Communication Software
Manufacturer	Siemens
Operating Systems	Windows, Linux
Protocols Supported	PROFIBUS, PROFINET, OPC UA
Compatibility	Siemens PLCs, Third-party devices with supported protocols