Network protocols
7.1 IPv4 protocol
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
293
Call up the command with the following parameters:
ip name-server ipv4 <ucast_addr> [index <id(1-3)>]
The parameters have the following meaning:
IP address of the DNS server Enter a valid IP address
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The IP address and, if specified, the index for a DNS server has been set.
no ip name server
Description
This command deletes the entry with the specified index for a DNS server. If you do not
specify an index, all entries are deleted.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
no ip name-server ipv4 <ucast_addr> [index <id(1-3)>]
The parameters have the following meaning:
IP address of the DNS server
enter a valid IPv4 address
The specified entries for the DNS servers were deleted.
To Next Page
Loading...
Need help?
General
