Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
426 Configuration Manual, 10/2015, C79000-G8976-C351-05
no vap communication with own-vap (access point)
Description
With this command, you specify that clients logged on to the same SSID of an access point
cannot communicate with each other.
Note
This command is avail
able only in access point mode.
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Call the command without parameter assignment:
no vap communication with own-vap
The communication option on the same SSID of an access point is disabled.
You display the settings with the show wlan security <vapX 0/Y> command.
You enable the function with the
vap communication with own-vap command.
vap communication with own-vap (access point) (Page 425)
To Next Page
Loading...
