Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
247
show spanning-tree mst interface
Description
This command shows port-specific settings of a Multiple Spanning Tree configuration.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with one of the following parameter assignments:
show spanning-tree mst
[<instance-id(1-64)>] interface<interface-type><interface-id>
[{stats|hello-time|detail}]
The parameters have the following meaning:
Number of the instance or range of instances
whose settings are displayed
1 ... 64
Type or speed of the interface Enter a valid interface.
Module no. and port no. of the interface
Shows the number of incoming and outgoing
packets for each path of the interface
-
Shows the intervals at which the root switch
sends its "Hello" message to the other
-
Shows detailed information about the select-
-
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The settings are displayed.
You display the general settings for the Spanning Tree Protocol with the show spanning-tree
command.
To Next Page
Loading...
Need help?
General
