Siemens SIMATIC NET

Layer 3 functions
9.1 NAT
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
378 Configuration Manual, 10/2015, C79000-G8976-C351-05
Further notes
You disable NAT with the no nat interface command.
You configure the MAC mode with the
wlan client mac mode command.
You show the NAT configuration and the translation list with the
show nat command.
See also
show nat (Client) (Page 371)
9.1.3.5
no nat interface (Client)
Note
This command is only available in the client mode.
Description
With this command, you disable NAT.
Requirement
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Syntax
Call the command without parameters:
no nat interface
Result
NAT is disabled.
Further notes
You enable NAT with the nat interface command.
See also
show nat (Client) (Page 371)