Network protocols
7.1 IPv4 protocol
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
283
show ip route
Description
This command shows the routes currently being used.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show ip route[{<ip-address>[<mask>]|connected|static}]
The parameters have the following meaning:
shows the information for a specific IP address enter a valid IP ad-
defines an address range using the subnet mask /8, /16 or /24
Shows the direct connections
Shows the static connections
The routing table is displayed.
To Next Page
Loading...
