Siemens SIMATIC NET

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
134 Configuration Manual, 10/2015, C79000-G8976-C351-05
6.1.1.4
show wlan ap (access point)
Description
The command displays the configuration parameters of the access point.
Note
This command is ava
ilable only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan ap <wlan 0/X>
The parameter has the following meaning:
Parameter
Description
Range of values / note
wlan 0/X
WLAN interface
Enter a valid interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The following settings of the access point are displayed:
● Channel
● Alternative channel
● HT channel width