Siemens SIMATIC NET Configuration Manual

Functions specific to SCALANCE
4.4 iPCF-MC
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
106 Configuration Manual, 10/2015, C79000-G8976-C351-05
4.4.2.3
wlan ipcf-mc cycle-time (access point)
Note
The com
mand is only available with the following device:
•
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
Description
With this command, you configure the cycle time for iPCF-MC.
Requirement
You are in the WLAN configuration mode.
The command prompt is as follows:
cli(config-wlan)#
Syntax
Call up the command with the following parameters:
wlan ipcf-mc cycle-time <ms (32-512)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
ms
Cycle time in millisec-
onds (ms)
32 ... 512
Result
The cycle time is configured.
Further notes
You display the setting with the show wlan ipcf-mc command.

Siemens SIMATIC NET Specifications

General

Category	Industrial Communication Software
Manufacturer	Siemens
Operating Systems	Windows, Linux
Protocols Supported	PROFIBUS, PROFINET, OPC UA
Compatibility	Siemens PLCs, Third-party devices with supported protocols