Network protocols
7.2 DHCP client
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
299
This section describes commands of the Dynamic Host Configuration Protocol (DHCP).
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
do show cli-console-timeout
show ip dhcp client stats
Description
With this command, you display the statistical counters of the DHCP client.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show ip dhcp client stats
The counters are displayed.
show ip dhcp client
Description
With this command, you display the configuration settings of the DHCP client.
To Next Page
Loading...
Need help?
General
