Siemens SIMATIC NET - Spanning-Tree Mst Max-Hops

Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
258 Configuration Manual, 10/2015, C79000-G8976-C351-05
Syntax
Call up the command with the following parameters:
spanning-tree mst{instance-id<instance-id(1-64)>}root
The parameters have the following meaning:
Parameter
Description
Range of values / note
instance-id
Keyword for the instance
-
instance-id
Number of the instance 1 ... 64
Result
The "root bridge" function is disabled.
Further notes
You enable the root bridge function with the spanning-tree mst instance-id root command.
You display this setting and other information with the commands that start with
show
spanning tree ...
.
6.3.3.12
spanning-tree mst max-hops
Description
With this command, you configure the maximum number of nodes (hops) that a path can run
through in an MST.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
spanning-tree mst max-hops <value(6-40)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
value
Maximum number of hops that a path
can run through in an MST
6 ... 40
Default: 20