EasyManuals Logo

Siemens SIMATIC NET Configuration Manual

Siemens SIMATIC NET
464 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #329 background imageLoading...
Page #329 background image
Network protocols
7.4 SNMP
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
329
7.4.1.9
show snmp targetaddr
Description
This command shows the configured SNMP target addresses.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show snmp targetaddr
Result
The configured SNMP target addresses are displayed.
7.4.1.10
show snmp targetparam
Description
This command shows the configured SNMP target parameters.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show snmp targetparam
Result
The configured SNMP target parameters are displayed.

Table of Contents

Other manuals for Siemens SIMATIC NET

Preview: Operating Instructions
Operating Instructions90 pages
Preview: Manual&Nbsp;
Manual&Nbsp;300 pages
Preview: System Manual
System Manual372 pages
Preview: Assembly Instructions
Assembly Instructions6 pages
Preview: Product Information
Product Information6 pages
Preview: Reference Manual
Reference Manual14 pages
Preview: Installation Manual
Installation Manual66 pages

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC NET and is the answer not in the manual?

Siemens SIMATIC NET Specifications

General IconGeneral
CategoryIndustrial Communication Software
ManufacturerSiemens
Operating SystemsWindows, Linux
Protocols SupportedPROFIBUS, PROFINET, OPC UA
CompatibilitySiemens PLCs, Third-party devices with supported protocols

Related product manuals