Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
312 Configuration Manual, 10/2015, C79000-G8976-C351-05
Commands in the DHCPPOOL configuration mode
This section describes commands that you can call up in the DHCPPOOL Configuration
mode.
In the Global Configuration mode, enter the
ip dhcp-server pool command to change to this
mode.
● If you exit the DHCPPOOL Configuration mode with the
exit command, you return to the
Global Configuration mode.
● If you exit the DHCPPOOL Configuration mode with the
end command, you return to the
Privileged EXEC mode.
Note
The command is only available with the following device:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
SCALANCE W761-1 RJ45 in access point mode (article number): 6GK5761-1FC00-
and 6GK5761-1FC00-0AB0 (US version))
With this command, you specify how long the assigned IPv4 address remains valid. Once
this period has elapsed, the device must either request a new IPv4 address or extend the
lease time of the existing IPv4 address.
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Call up the command with the following parameters:
lease-time <seconds (60-31536000)>
The parameter has the following meaning:
Time until renewal of the assigned
60 ... 31536000
To Next Page
Loading...
Need help?
General
