Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
40 Configuration Manual, 10/2015, C79000-G8976-C351-05
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available counters.
The counters of the selected interfaces are displayed.
show interface mtu
Description
With this command, you show the setting for the Maximum Transmission Unit (MTU) of the
interfaces on the device.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show interface mtu [{Vlan<vlan-id(1-4094)>|
<interface-type><interface-id>}]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If no parameters are specified, the settings for all interfaces are displayed.
The settings are displayed.
To Next Page
Loading...
Need help?
General
