Network protocols
7.1 IPv4 protocol
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
288 Configuration Manual, 10/2015, C79000-G8976-C351-05
ip echo-reply
Description
To check the availability of a network node, packets of the Internet Control Message Protocol
(ICMP) can be sent to it. These packets of type 8 request the recipient to send a packet back
to the sender (echo reply).
With this command you enable the network node to react to ping queries.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
ip echo-reply
"ICMP echo reply messages" are enabled. The network node reacts to ping queries.
You disable the setting with the no ip echo-reply command.
no ip echo-reply
Description
With this command you stop the network node reacting to ping queries.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
no ip echo-reply
"ICMP echo reply messages" are disabled. The network node does not react to ping queries.
You change the setting with the ip echo-reply command.
To Next Page
Loading...
Need help?
General
