Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
318 Configuration Manual, 10/2015, C79000-G8976-C351-05
Note
The command is only available when the following requirements are met:
SCALANCE W722-1 RJ45 (article no.: 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-
0AB0 (US version))
SCALANCE W761-1 RJ45 in access point mode (article number): 6GK5761-1FC00-
and 6GK5761-1FC00-0AB0 (US version))
The IPv4 address band is not enabled.
With this command, you delete the DHCP option with the specified number.
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Call up the command with the following parameters:
no option <option-code>
The parameter has the following meaning:
The specified DHCP option is deleted.
You configure the DHCP option 67 with the option value-string command.
You configure the DHCP options 3, 6 and 66 with the
option command.
You configure all other DHCP options with the
option value-hex command.
To Next Page
Loading...
Need help?
General
