Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
390 Configuration Manual, 10/2015, C79000-G8976-C351-05
The settings are displayed.
wlan security ap-radius-authenticator (Page 391)
wlan security ap-radius-authenticator address (Page 393)
wlan security ap-radius-authenticator max-retransmit (Page 394)
wlan security ap-radius-authenticator port-number (Page 395)
wlan security ap-radius-authenticator primary (Page 396)
no wlan security ap-radius-authenticator primary (Page 397)
wlan security ap-radius-authenticator reauth-interval (Page 398)
wlan security ap-radius-authenticator reauth-mode (Page 399)
wlan security ap-radius-authenticator shared-secret (Page 400)
show wlan security keys
Description
This command shows a table with the WEP key of the SCALANCE W700 device.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show wlan security-keys < wlan 0/X >
The parameters have the following meaning:
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The key table is displayed.
To Next Page
Loading...
Need help?
General
