Diagnostics
11.2 Syslog client
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
455
You disable the setting with the no syslogserver command.
You can display the status of this function and other information with the
show events config
command.
no syslogserver
Description
With this command, you configure the Syslog server address.
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli (config-events) #
Call up the command with the following parameters:
syslogserver {ipv4 <ucast_addr> | fqdn-name <FQDN>}
The parameters have the following meaning:
Keyword for an IP address
Syslog server IPv4 Address
Enter a valid IPv4 address.
Keyword for a domain name
Domain name (Fully Qualified Domain
Maximum of 100 characters
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The settings for the Syslog server are disabled.
You enable the setting with the syslogserver command.
You can display the status of this function and other information with the
show events config
command.
To Next Page
Loading...
Need help?
General
