Siemens SIMATIC NET Configuration Manual

Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
44 Configuration Manual, 10/2015, C79000-G8976-C351-05
Syntax
Call the command without parameters:
show versions
Result
The following settings are displayed:
● Basic device
● Name
● Revision
● Order ID
● Firmware
● Bootloader
● Description
● Version
● Date
3.1.2
clear counters
Description
With this command, you reset the counters of an interface.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
clear counters [<interface-type><interface-id>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
interface-type
Type or speed of the interface
Specify a valid interface.
interface-id
Module no. and port no. of the interface

Siemens SIMATIC NET Specifications

General

Category	Industrial Communication Software
Manufacturer	Siemens
Operating Systems	Windows, Linux
Protocols Supported	PROFIBUS, PROFINET, OPC UA
Compatibility	Siemens PLCs, Third-party devices with supported protocols