Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
192 Configuration Manual, 10/2015, C79000-G8976-C351-05
The parameters have the following meaning:
Index entry in the SSID list
Entry is used --
Entry is deleted. The ssid pa-
rameter is ignored.
--
SSID Enter the SSID of the access point.
The length of the character string for SSID
is 1 to 32 characters. ASCII code 0x20 to
0x7e is used for the SSID.
To be able to use spaces in the SSID, enter
the SSID in quotes:
wlan ssid-table edit "H a l l o"
The corresponding index entry in the SSID list is changed or deleted.
You display the list with the show wlan ssid-table <wlan 0/X> command.
You delete an SSID entry with the
wlan ssid-table edit <index (1-8)> delete command.
wlan force roaming eth-down (access point)
Description
If the wired Ethernet interface is no longer available (cable break, connector removed), a
client connected over the wireless network is not aware of this.
The access point can force the logged-on clients to roam by deactivating its WLAN interface.
The client then attempts to log on at a different access point. With this command, you enable
this function.
Note
This command is available only in access point mode.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
To Next Page
Loading...
Need help?
General
