Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
308 Configuration Manual, 10/2015, C79000-G8976-C351-05
ip dhcp-server icmp-probe
Note
The command is only available with the following device:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
SCALANCE W761-1 RJ45 in access point mode (article number): 6GK5761-1FC00-
and 6GK5761-1FC00-0AB0 (US version))
With this command, you enable the "Probe address with ICMP Echo before offer" function.
The DHCP server checks whether or not the IPv4 address has already been assigned. If no
reply is received, the DHCP server can assign the IPv4 address.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameter assignment:
ip dhcp-server icmp-probe
The function is enabled.
You disable the function with the no ip dhcp-server icmp-probe command.
To Next Page
Loading...
Need help?
General
