Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
204 Configuration Manual, 10/2015, C79000-G8976-C351-05
The indoor mode is enabled or the outdoor mode is disabled.
You display the setting with the show wlan basic <wlan 0/X> command.
You enable the outdoor mode with the
wlan outdoor command.
wlan outdoor (Page 203)
wlan overlap-ap aging (access point)
Description
With this command, you configure the aging time for the list of overlapping access points. If
an access point is inactive for longer than the set time, it is removed from the list.
Note
This command is available only in access point mode.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call up the command with the following parameters:
wlan overlap-ap aging <min(1-7200)>
The parameter has the following meaning:
Time in minutes (min) 1...7200
The aging time is specified.
You display the setting with the show wlan advanced <wlan 0/X> command.
To Next Page
Loading...
Need help?
General
