Description
2.4 Symbols of the CLI commands
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
24 Configuration Manual, 10/2015, C79000-G8976-C351-05
Symbols of the CLI commands
Symbols for representing CLI commands
When setting parameters for CLI commands, the following characters are used:
Instead of the expression in parenthesis, enter a value.
[ ... ] optional parameter Instead of the expression in parenthesis, you can enter a
Instead of the expression in parenthesis, enter a value.
( ... - ... ) Range of values Enter a value from this range.
Select one more elements from the list.
Select exactly one element from this list.
These characters are used in combinations to describe mandatory and optional entries.
There is a general description of some of these combinations below:
< Parameter > Instead of the expression in parentheses<>, enter a
< < Unit (a - b) > Instead of the expression in parentheses <>, enter a
value from the range "a" to "b".
The unit to be used is specified before the brackets ()
and is also replaced by the entry.
[<Parameter 1 >< Parameter 2 >] The parameter pair is optional.
If you use the parameter assignment, you need to
enter a permitted value to replace both expressions in
[ [ Keyword < Unit (a - b)>] The parameter assignment is optional.
If you use the keyword, you need to enter a value
from the range "a" to "b" to replace the expression in
[keyword { A | B | C }] The parameter assignment is optional.
If you use the keyword, you need to specify exactly
one of the values "A", "B" or "C".
Keyword [A] [B] [C] After the keyword, enter no or several of the values
To Next Page
Loading...
Need help?
General
