Configuration
3.4 Configuration Save & Restore
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
82 Configuration Manual, 10/2015, C79000-G8976-C351-05
Configuration Save & Restore
This section describes commands for displaying, saving and restoring configuration settings.
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
do show cli-console-timeout
show running-config
Description
This command shows configuration settings of the device.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show running-config
[{
syslog|dhcp|qos|stp|vlan<vlan-id(1-4094)>|
interface
{
<interface-type><interface-id>|
vlan<vlan-id(1-4094)>
}|
ssh|ssl|acl|ip|snmp|radius|sntp|http|locked-port|
auto-logout|time|
ntp|auto-save|wlan
}][all]
To Next Page
Loading...
Need help?
General
