Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
165
wlan amsdu packet-size
Description
With this command, you specify the maximum size of the A-MSDU data packet.
● The IEEE 802.11n transmission standard is enabled.
● You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call up the command with the following parameters:
wlan amsdu packet-size <size (50-200)>
The parameter has the following meaning:
Values or range of values
Maximum size of the A-MSDU data pack-
et.
50...200 bytes
The size of the A-MSDU data packet is specified.
You display the setting with the show wlan advanced-11n <wlan 0/X> command.
wlan antenna additional-attenuation
Description
With this command, you specify the additional attenuation caused, for example by an
additional splitter. Using the
show wlan basic command, check whether or not the current
WLAN settings violate the permitted transmit power restrictions (
TX Power Check) of the
selected country.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
To Next Page
Loading...
Need help?
General
