Siemens SIMATIC NET Configuration Manual

System time
5.1 System time setting
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
117
The parameters have the following meaning:
Parameter
Description
Range of values / note
name
Name of the entry
maximum 16 characters
year
Year 1900 ... 2099
begin
Keyword for the start of daylight saving
time.
-
MMDDhh
Time for the start of daylight saving
time.
Time in the format
MM Month
DD Day
hh Hour
end
Keyword for the end of daylight saving
time.
-
MMDDhh
Time for the end of daylight saving
time.
Time in the format
MM Month
DD Day
hh Hour
Result
The entry for the start and end of daylight saving time was created.
5.1.2.4
time dst recurring
Description
With this command, you configure the start and end of daylight saving time with a generic
description.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
time dst recurring <name(16)> begin {<week(1-5)> | last} <weekday> <month> <hour> end
{<week(1-5)> | last} <weekday> <month> <hour>

Siemens SIMATIC NET Specifications

General

Category	Industrial Communication Software
Manufacturer	Siemens
Operating Systems	Windows, Linux
Protocols Supported	PROFIBUS, PROFINET, OPC UA
Compatibility	Siemens PLCs, Third-party devices with supported protocols