Siemens SIMATIC NET

Network protocols
7.4 SNMP
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
349
Result
Write access for SNMPv1 and SNMPv2 PDUs is enabled.
Further notes
You block write access for SNMPv1 and SNMPv2 PDUs with the snmp v1-v2 readonly
command.
7.4.2.20
snmp user
Description
With this command, you configure the details of an SNMP user.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp user <UserName>[auth{md5|sha} <passwd>[priv DES<passwd>]]
[{volatile|nonvolatile}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
UserName
Name of the user
max. 32 characters
auth
specifies that authentication takes
place and which algorithm is used
•
md5 (Message Digest 5)
•
sha (Secure Hash Algorithm)
Default: No authentication
passwd
Password for authentication
max. 32 characters
priv DES
specifies that there is encryption -
Default: no encryption
passwd
Value for the password of the encryp-
tion
max. 32 characters
Storage type specifies whether the settings remain
following a restart:
•
volatile (volatile):
The default settings are used
after a restart
•
nonvolatile (non-volatile):
The saved settings are used
after a restart
If optional parameters are not specified when configuring an SNMP user, the defaults values
apply.