Siemens SIMATIC NET Configuration Manual

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
166 Configuration Manual, 10/2015, C79000-G8976-C351-05
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan antenna additional-attenuation <index (1-X)> <dB(0-70)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
index
Antenna connector
X = 1
dB
Attenuation in decibels [dB] 0...70
Default: 0
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)"
Result
The additional attenuation is specified.
Further notes
You show the set value with the show wlan antennas <wlan 0/X> command.
6.1.5.13
wlan antenna cable-length
Description
With this command, you configure the cable length between the SCALANCE W700 device
and the external antenna.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan antenna cable-length <index(1)> <meter(0-30)>

Siemens SIMATIC NET Specifications

General

Category	Industrial Communication Software
Manufacturer	Siemens
Operating Systems	Windows, Linux
Protocols Supported	PROFIBUS, PROFINET, OPC UA
Compatibility	Siemens PLCs, Third-party devices with supported protocols