Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
56 Configuration Manual, 10/2015, C79000-G8976-C351-05
no cli-console-timeout
Description
With this command, you disable the automatic logout.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
no cli-console-timeout
Automatic logout is disabled.
You enable automatic logout with the cli-console-timeout command.
You display the current timeout setting with the
show cli-console-timeout command.
With this command, you configure the setting for PNIO after the next restart of the device.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
pnio {off|on}
To Next Page
Loading...
Need help?
General
