Security and authentication
10.3 Management Access Control List
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
429
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
do show cli-console-timeout
show authorized-managers
Description
This command shows the information about the configuration of the authorized managers.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show authorized-managers[ip-source<ip-address>]
The parameters have the following meaning:
Keyword for the network or host ad-
-
Value for an IP address specify a valid IP address
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The information about the configuration of the authorized managers is displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
To Next Page
Loading...
Need help?
General
