Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
153
You display the settings for the mode with the show wlan device command.
show wlan device (Page 141)
With this command, you specify when the modified WLAN settings become effective on the
SCALANCE W700 device.
You are in the WLAN Configuration mode.
The command prompt is as follows:
cli(config-wlan)#
Call up the command with the following parameters:
commit mode { auto | manual }
The parameters have the following meaning:
Each change to the WLAN settings is automatically applied and is immediately effec-
The changes are accepted, but are still not active. The changes only take effect when
you confirm the changes with the "commit wlan-settings" command.
The commit mode is specified.
You show the settings for the commit mode with the show wlan device command.
show wlan device (Page 141)
commit wlan-settings (Page 154)
To Next Page
Loading...
Need help?
General
