Network protocols
7.1 IPv4 protocol
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
284 Configuration Manual, 10/2015, C79000-G8976-C351-05
show ip telnet
Description
This command shows the admin status and the port number of the Telnet server.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show ip telnet
The admin status and the port number of the Telnet server are displayed.
This command shows information about the DNS client, for example the status of the DNS
client and parameters for querying the DNS server.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show ip dns
Information on the DNS client is displayed.
To Next Page
Loading...
