Siemens SIMATIC NET

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
148 Configuration Manual, 10/2015, C79000-G8976-C351-05
6.1.1.18
show wlan wds (access point)
Description
This command shows the configuration of the WDS interface.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan wds <wdsX 0/Y>
The parameter has the following meaning:
Parameter
Description
Range of values / note
wdsX 0/Y
WDS interface
Enter a valid interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The following WDS settings are displayed:
● Admin status
● Connection over
● Partner ID type
● Partner MAC
● Partner WDS ID