Siemens SIMATIC NET Configuration Manual

Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
42 Configuration Manual, 10/2015, C79000-G8976-C351-05
3.1.1.10
show pnio
Description
This command shows the current PROFINET IO configuration.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show pnio
Result
The current PROFINET IO configuration is displayed.
3.1.1.11
show lldp neighbors
Description
This command shows the current content of the neighborhood table.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show lldp neighbors
Result
The neighborhood table is displayed.

Siemens SIMATIC NET Specifications

General

Category	Industrial Communication Software
Manufacturer	Siemens
Operating Systems	Windows, Linux
Protocols Supported	PROFIBUS, PROFINET, OPC UA
Compatibility	Siemens PLCs, Third-party devices with supported protocols