Siemens SIMATIC NET

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
177
6.1.5.24
wlan client mac address (client)
Description
With this command, you specify the MAC address of the client.
Note
This command is only available in the client mode.
Requirement
● The MAC address is assigned to the client manually.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan client mac address <mac address>
The parameter has the following meaning:
Parameters
Description
Range of values / note
mac address
MAC address of the client
aa:aa:aa:aa:aa:aa
Result
The MAC address was assigned to the client.
Further notes
You display the setting with the show wlan client <wlan 0/X> command.