Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
217
This section describes commands for configuring and managing virtual networks (VLANs).
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
do show cli-console-timeout
show dot1d mac-address-table
Description
This command shows the table with the static and dynamic unicast entries and the dynamic
multicast entries.
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Call up the command with the following parameters:
show dot1d mac
-address-table [address <aa:aa:aa:aa:aa:aa>]
[interface {<interface-type> <interface-id>}]
The parameters have the following meaning:
Keyword for a MAC address
MAC address Specify a valid MAC ad-
dress.
Keyword for a an interface description
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
To Next Page
Loading...
Need help?
General
